Publicité
Les langues disponibles
Les langues disponibles
Cleaning the rear squeegee suction hose
• Remove the dirty water tank and the detergent tank and set them on the floor,
referring to the section "Emptying the water/detergent tank" and
"Emptying the dirty water tank".
• Pull the handle up perpendicular to the machine.
• Lower the squeegee by operating the lever.
• Tilt the machine backwards and rest the handle on the floor.
• Detach the hose from the diverter valve and from the rear squeegee (fig. 33, ref. 1).
• Wash the hose by directing water into the bore (fig. 32)
• Reattach the hose
Cleaning the diverter valve
! INFORMATION: This procedure should take place in an area suitable for servicing operations, as the floor will
become dirty and wet.
! WARNING: Wear overalls, non-slip shoes, gloves and all other items of PPE appropriate for the work environment.
• Remove the dirty water tank and the detergent tank and set them on the floor, referring to
the section "Emptying the water/detergent tank" and "Emptying the dirty water tank".
• Detach the front squeegee suction hose from the diverter valve.
• Detach the rear squeegee suction hose from the diverter valve.
• Release the retaining lever (fig. 35, ref. 1) and remove the cover of the diverter valve.
• Clean the chamber of the valve (fig. 36, ref. 1), removing any encrustations, and rinse with
clean water; wipe the seals of thecover with a soft cloth.
Cleaning the squeegee
! WARNING: Do not clean seals with ethyl alcohol.
• Remove the dirty water tank and the detergent tank and set them on the floor, referring to
the section "Emptying the water/detergent tank" and "Emptying the dirty water tank".
• Pull the handle up perpendicular to the machine.
• Tilt the machine backwards and rest the handle on the floor.
• Clean the blades of both squeegees with a moist cloth (fig. 37, ref. 1).
• Clean the suction inlet port of both squeegees (fig. 37, ref. 2).
Squeegee adjustment
The squeegee is factory-adjusted to give an optimum drying action on different types of floor surface,
but in the event that results do not meet expectations, there are further adjustments that can be
made. To ensure a faultless drying action, the lip of the squeegee blade should deflect 45° along its
entire length, relative to the floor surface; the height of the squeegee can be adjusted by raising or
lowering the wheels (fig. 38, ref. 1).
16
Operations Manual
Micro-5
Publicité
