Dustbane Micro-5 Manuel D'opération page 11

Preparing the machine for work
Proceed as follows before starting work:
• Check that the display shows the batteries to be fully charged. Recharge if necessary. See the "Battery maintenance
and charging" section.
• Make certain that the dirty water tank is empty, and if not, empty it, referring to the section "Emptying the dirty water
tank".
• Make certain that the detergent solution tank is full, and if not, proceed to fill it, referring to the section "Filling the water/
detergent tank".
• Adjust the position of the handle, referring to the section "Adjusting the handle rake angle".
• Fit the brush, referring to the section "Fitting the brush/pad driver".
Controls
The machine has the following controls and indicator lights:
• Main switch (fig. 14, ref. 1): connects and disconnects electrical power to and from all functionsof the machine.
• Power on light (mains powered model) (fig. x, ref. x): colour yellow, indicates that the power cable of the machine is
connected to the mains supply and the main switch has been depressed (fig. 14, ref. 1).
• Battery charge indicator (battery powered models only) (fig. 15, ref. 1): consists of 3 Leds, red, yellow and green, showing
the battery charge level. Possible charge level indications:
• Green Led light: battery charge > 30.0 %.
• Yellow Led light: battery charge between 10% and 30%.
• Red Led light: battery charge between 5% and 10%.
• Red Led blinking: battery charge < 5%, battery completely flat; after a few seconds the brush motor and
suction motor will be shut off;
• Brush control button (fig. 15, ref. 2): enables (Led alight) and disables (Led dark) operation of the "Brush" function; the
brush does not start rotating until the "Brush control lever"(fig. 15, ref. 2) is operated.
! INFORMATION: Pressing the brush control button also has the effect of automatically enabling the suction and detergent solution flow
functions, which can then be controlled and adjusted by way of the respective single buttons on the console.
• Suction control button (fig. 15, ref. 3): switches on ("Led ON") and switches off ("Led OFF") the suction motor, which
generates the vacuum needed to dry the floor after scrubbing. The motor comes into operation only when activated by
way of the "Brush control lever".
• Detergent flow button (fig.15, ref. 5): enables (Led ON) and disables (Led OFF) the flow of detergent solution, with three
levels of delivery available. Flow is enabled only with the brush in operation.
• ECO button (fig.15, ref. 4): enables (Led ON) and disables (Led OFF) ECO operating mode.
! INFORMATION: In ECO operating mode, the power of the brush motor and suction motor is reduced automatically and the flow of
detergent solution defaults to delivery level 1.
Operations Manual Micro-5
11