Dustbane Micro-5 Manuel D'opération page 10

The battery used in this machine could pose a risk of fire or chemical burns if treated carelessly or improperly; it must not be
dismantled, and should be kept well clear of children. Whilst the battery will normally come fully charged and ready for use, it is
good policy nonetheless to run a recharge cycle before the machine is put into service, proceeding as indicated below:
• Insert the jack plug of the battery charger into the socket on the battery (fig. 13).
• Plug the battery charger into the mains power socket.
• Wait for the recharge cycle to finish; the Led on the battery charger will turn green.
• Disconnect the battery charger from the power socket and from the battery.
Batteries: removal
! DANGER: The battery can be removed only with the machine switched off.
Press the two sliding release catches and remove the battery from its housing (fig. 13A, ref. 1).
! WARNING: Never allow the batteries to become excessively flat as this could damage them irreparably.
Batteries: disposal
! INFORMATION: Ensure the battery is disposed of correctly, in compliance with current local environmental regulations. Do not throw the
battery away as household refuse.
PRACTICAL GUIDE FOR THE OPERATOR
! WARNING: To avoid damaging the surface of the floor being cleaned, do not leave the brushes rotating with the machine stationary.
! WARNING: Always dilute the detergent according to the manufacturer's instructions. Do not use sodium hypochlorite (bleach) or other
oxidants, particularly in strong concentrations. Do not use solvents or hydrocarbons. The water and detergent temperature must not
exceed the maximum indicated in the "Technical specifications". There must be no sand and/or other impurities in the solution.
! DANGER: Before starting work, put on overalls, non-slip shoes, gloves and all other personal protection devices recommended by the
supplier of the detergent used or appropriate for the type of work environment.Follow the safety regulations on use of detergents given
in the section "Safety regulations".
10
Operations Manual Micro-5