Amana NFW7200TW Caractéristiques Techniques page 9

Troubleshooting
To avoid risk of electrical shock, personal injury or death; disconnect power to washer before servicing, unless
testing requires power.
Selection Component
Rotary cycle
Main Relay
selector set to
Super Wash.
Press Rotary
Selector Knob.
Rotary cycle Hot Water Valve
selector set to
Normal. Press
Rotary Selector
Knob.
Rotary cycle
Cold Water Valve
selector set to
Wrinkle Control.
Press Rotary
Selector Knob.
Rotary cycle Bleach Valve
selector set to
Delicates. Press
Rotary Selector
Knob.
Rotary cycle Softener Valve
selector set to
Hand Wash.
Press Rotary
Selector Knob.
Rotary cycle Drain Pump
selector set to
Quick Wash.
Press Rotary
Selector Knob.
Press Delay Motor
switch pad
Press Chime Door Lock
switch pad
Press Door Lock
Temperature
switch pad
WARNING
Function
On to Off or
rotating the cycle select knob. The display will show a
Off to On
"d".
Rotating the Cycle Selector knob in either direction
will cycle through the list of codes one code at a time
1st press valve on.
with no wrap. Once an initial direction is selected by
2nd press valve off.
the user (either Clockwise or Counterclockwise),
subsequent movements of the knob in the same
direction will show older codes. If the user changes
direction and turns the knob in the opposite direction,
1st press valve on. the more recent code will be displayed. If rotation is
2nd press valve off.
continued to the limits of the list, the display will
remain at the top or the end of the list. A pair of
dashes "- -" will be displayed at the end of the list of
codes, when the control reaches the top, it will again
show "d".
1st press valve on.
2nd press valve off.
A code generated during the current cycle will be
displayed with the Spin Indicator LED turned "ON". If
no cycle is currently running, a code generated during
the previous cycle will be displayed with the Spin
1st press valve on.
Indicator LED turned "ON".
2nd press valve off.
Access Other Features
While a diagnostic code is displayed, if the Rotary
Selector is pressed and held, the machine will display
1st press Drain
the number of cycles since the diagnostic code
Pump on. 2nd
occurred. To clear the diagnostic list press the Delay
press Drain Pump
and Chime keys for 3 seconds while viewing the list.
off.
1st press Motor on.
2nd press Motor
off.
1 Attempt to unlock
Lock Door
9
Display Diagnostic Codes
The diagnostic code display can be
toggled on and off from Service Mode
by pressing the Rinse&Spin key and