Publicité
Les langues disponibles
Les langues disponibles
Troubleshooting
To avoid risk of electrical shock, personal injury or death; disconnect power to washer before servicing, unless
testing requires power.
Diagnostic Codes
Diag.
Description
Code
1
No Drain
The door/lid
2
fails to unlock
3
No Fill
The door/lid
4
fails to lock
5-7
Water level
8
sensor fault.
9
Unbalance or
cabinet hit
detected
during final
spin, which
10
prevented the
spinner from
exceeding
400 rpm
Action to be
Trigger
taken
The water level
fails to drop below
Displays "nd"
the Low Water
Go to "Will Not
level reset within
Drain"
15 minutes, before
Troubleshooting
a spin
Section
begins.
Displays "LO"
Door failed to
Go to "Will Not
unlock after 3
Unlock"
attempts
Troubleshooting
Section
Displays "nF"
Continuous fill
Go to "No
of 12 minutes.
Water Fill"
Total fill of 14
Troubleshooting
minutes.
Section
Displays "FL"
Go to "Will not
Door failed to lock
lock"
after 3 attempts
Troubleshooting
Section.
Not Used
Input signal
from water
Displays "LE"
level Sensor
Go to "No
is out of
water fill"
range,
Troubleshooting
Washer will
Section.
beep and
pause the
wash cycle.
Not Used
Never
Will display
"dc" "Wet
exceeded 400
rpm due to an
Clothes"
Troubleshooting
unbalanced
load.
Section
WARNING
Diag.
Description
Code
sensor level
E
11
remember
12-14
15
Stuck Key
switch was not
17
seen open
since the last
three final
10
Trigger
Water level in
the machine
is believed to
be above the
overflow
level. When
this condition
is detected,
the machine
Water
will
fault.
automatically
begin
pumping
water out of
the machine
until it falls
below the
overflow
level.
Will not
Difficulty in
machine
reading memory
settings
Not Used
A key is sensed to
be pressed more
than 30 seconds,
the key will be
assumed to be
stuck
The door has not
been opened after
Door/Lid
two complete
wash cycles.
Door switch was
not seen open
spins
since the last two
final spins
Action to be
taken
First check to
see
that water
valve is
not stuck. If
water
valve is OK,
check
water level
sensor
Go to "Clear
diagnostic
codes"
Disconnect
and reconnect
the washer
power cord at
power supply
outlet. If
condition still
exists, replace
machine
control board.
Display "E2".
Go to
"Membrane
Pad Check"
Check
connection of
keypad to
control board.
Replace
console if
necessary.
Will display
"od" If door
open sensing,
will cleared.
Publicité
