Error Messages - Triton 4739 Mode D'emploi

TROUBLESHOOTING

ERROR MESSAGES

ERROR ERROR
CODE TYPE
100 WARNING Treatment has been running for 8 seconds, but no tension is
detected on the rope.
101 WARNING Patient pressed Patient Interrupt Switch.
102 WARNING Patient Interrupt Switch is unplugged.
104 WARNING User selected Patient Card button on Utilities Screen, but no
traction treatments were found on the card.
105 WARNING User selected Save To Card, but no card is inserted into the
unit.
106 WARNING User selected Save To Card, but the card currently inserted is
not a Patient Card.
107 WARNING User selected Save To Card, but the card currently inserted
is full.
108 WARNING User typed in a blank Patient Name.
112 WARNING Error upgrading Control Board Software.
113 WARNING Error upgrading Motor Board Software.
114 WARNING User pressed START, but has not yet set the Max Level value
to a value greater than zero.
115 WARNING User pressed HOME button from treatment review screen
while a treatment was running.
DEFINITION
Too much slack in Traction Cord.
Patient Interrupt Switch button pressed.
Patient Interrupt Switch not properly connected to unit.
Wrong or bad Patient Data Card inserted into unit.
No Patient Data Card is inserted.
Wrong or bad Patient Data Card inserted into unit.
Memory full on Patient Data Card used.
No Patient ID assigned.
Unknown
Unknown
User has not completed Treatment Setup.
Home button has been pressed.
PROBABLE CAUSES
56
POSSIBLE REMEDY
Remove Traction Cord slack.
Touch the Touch Screen to clear the message.
Properly connect Patient Interrupt Switch and touch the Touch
Screen to clear message.
Insert correct Patient Data Card.
Properly insert correct Patient Data Card into unit.
Insert correct Patient Data Card.
Save Data to PDMS and erase Patient Data Card.
Enter Patient ID.
Contact Dealer or Chattanooga Group for Service.
Contact Dealer or Chattanooga Group for Service.
Complete Treatment Setup prior to pressing Start.
Press Stop To End Treatment prior to pressing Home.
Triton® Traction