Mounting Unit On Table - Triton 4739 Mode D'emploi

SETUP

MOUNTING UNIT ON TABLE

The Triton traction unit was designed to be utilized with Chattanooga
Group traction tables:
• Do not operate the unit when connected to any unit other than
Chattanooga Group devices. Do not use devices manufactured by
other companies on Chattanooga Group equipment. Chattanooga
Group is not responsible for any consequence resulting from using
products manufactured by other companies.
• To prevent accidental disengagement, this unit must be securely
attached to the mounting surface of the pedestal or traction stand. It
is the responsibility of the user to verify the adequacy of the
installation before use in patient therapy.
NOTE: The Triton traction unit should be mounted facing the direction
of pull so the Traction Cord does not contact the side of the slot
from which it extends.
22
Triton® Traction
1. To secure the traction unit to the
mounting surface, first loosen the
Clamp Knob by turning to the left.
Fit the unit to the mounting
surface, then turn the Clamp Knob
to the right, tightening the clamp
and securing the unit in place.
2. Remove the cover on the back
of the unit and connect the Mains
Power Cord (female end) to the
Mains Power Cord Receptacle.
3. Verify that there is a good
connection between the Mains
Power Cord and the Mains Power
Cord Receptacle. Always make
certain that the Mains Power Cord
is properly plugged into the unit.
4. Check the voltage rating on the
serial plate located on the back of
the unit. Plug the Mains Power
Cord into a 100V-240V AC outlet,
as required. Replace the cover on
the back of the unit.