Removing The Semg Module - Triton 4739 Mode D'emploi

SETUP
REMOVING OF THE sEMG MODULE
• Disconnect the traction unit from the power source before attempting
any maintenance, installation, removal, or replacement procedures to
prevent electrical shock and possible damage to the unit.
Turn the unit off. Disconnect the
traction unit from its power source.
Disconnect the Patient Interrupt
Switch and the sEMG lead wire from
the receptacles.
Gently press the tabs underneath
the unit, pull and remove the sEMG
Module from the traction unit
25
Triton® Traction
Gently push the front panel back into
the front of the traction unit. Once
the plastic of the unit and the front
panel are aligned, the connector
should be inserted properly, with the
tabs locked in place.
Plug the traction unit back into the
power source. Connect the Patient
Interrupt Switch into its receptacle.
Turn the unit on.
The traction unit should automatically
recognize that the sEMG Module
has been removed, with the sEMG
Traction button now being inactive
on the Home Screen.