Stiga MPST 84 Li 48 V1 Manuel D'utilisation page 121

Emergency pushbutton icon
The icon in fig. 13.Q is illuminated
if the emergency button is
activated (see par. 6.5).
6.9.2 Pushbutton panel (type "II") fig. 13
Machine start button
With the key fully inserted this
button (fig. 13.A) turns the machine
ON and enables all functions.
NOTE
If all safety conditions are met,
the "READY" icon comes ON (fig.
13.K) and the machine is ready
to be used (see chap. 7.4).
Cutting means engage and
disengage pushbutton
Press the button fig. 13.B to engage/
disengage the cutting means.
• When the cutting means
are engaged, they become
operational after a few seconds.
• When the cutting means are
disengaged, a brake is applied
simultaneously to stop them
rotating after a few seconds.
NOTE
If the cutting means are engaged
without taking the necessary
safety precautions, the machine
shuts down and cannot be
restarted (see par. 7.2.2)
Reverse gear cutting
enable button
Holding down the button
fig. 13.C gives consent
for reverse mowing.
For reverse cutting, engage the
cutting means and simultaneously
hold down the button.
NOTE
A single buzzer signal indicates the
lack of consent for reverse cutting.
Beacon ON button
Pushing the button fig. 13.D turns
the beacon on/off.
When the beacons are ON,
icon fig. 13.L is illuminated
"CRUISE CONTROL" button
Pressing the button in fig. 13.G
activates/deactivates the
"CRUISE CONTROL" function.
The Cruise Control command is
used to maintain the desired speed
in forward gear without having to
keep the drive pedal pressed.
• By pressing the "CRUISE
CONTROL" button (Fig. 13.G)
while moving forwards, the
machine will maintain the
speed reached at that moment,
without the driver having to act
on the drive pedal (Fig. 12.F).
When the function is active, the
icon in fig. 13.I. is illuminated
NOTE
The "CRUISE CONTROL" function
cannot be activated in reverse gear.
NOTE
Speeds may vary with respect to the
selected values when the machine
is moving up or down slopes.
To disengage the device and
reset speed control using the
drive pedal (fig. 12.F) simply:
• press the button fig. 13.G.
or
• press the drive pedal (fig. 12.F).
EN - 15