Klarstein KALAHARI Mode D'emploi page 52

EN
52
Remove the door
• Full open the door.
• Fold up the right and left side of the locking rod
(picture A).
• Close the door until reach to stop step, hold on both
left and right sides of the door, then reclose the door,
upward and downward and pull out the door.
Install the oven door
• The installation is carried out in reverse order.
• When installing the oven door, make sure both hinge
plug into opening mouth directly.
• Both sides of hinge rabbet must bite up each other.
• When open the door, spread down locking rod
(picture B).
Remove and install the door panel
Remove the door panel
• Remove the oven door and put it on a piece of cloth.
• Using one hand to push the outside glass, the other
hand to pull the inside glass, hold the glass then pull
out the glass.
CAUTION
Risk of glass breakage! If the glass has some scratches, it may lead
to crack. Don't use the glass spatula, acute and corrosive cleaning
product or detergent to clean the glass.
Install the door panel
• Plug the inner glass into glass pressure groove.
• Both right and left sides need put down alignment to
card slot and push the glass to its place.
• Put on the oven door.