Klarstein KALAHARI Mode D'emploi page 45

• To cancel the end of cooking timer press the programme button (12) four times to
select the end of cooking timer and then reduce the time to the current time of day.
• To cancel the automatic timer press the programme button (12) three times and
reduce the (duration) time to "00:00" and then press the programme button (12)
again and reduce the (end) time to the current time of day.
Note: If you do not turn the oven function selector knob and thermostat control knob
to their "OFF" positions, when you reset the timer function, it will continue to heat.
Adjusting the audible signal
The audible signal has 3 tones. To adjust the signal you should proceed as follows:
Note: The oven timer must not be in any form of countdown mode and the "Oven in
use" symbol (8) must be lit.
1 Press and hold down the minus (13) and plus (1 1) buttons simultaneously for
2 seconds and you will hear an audible signal. This is the audible signal which is
currently set.
2 Halten Sie die Minus- (13) und Plus- (1 1) Tasten erneut 2 Sekunden lang
gleichzeitig gedrückt, um das nächste akustische Signal zu hören, das zur Auswahl
steht. Dieser Vorgang kann wiederholt werden.
3 Wenn Sie das von Ihnen gewünschte akustische Signal hören, lassen Sie alle Tasten
los und warten Sie, bis das Display wieder die Uhrzeit anzeigt. Das akustische
Signal ist nun eingestellt.
Changing the time of day
Note: The oven timer/programmer must not be in any form of countdown mode and
the "Oven in use" symbol (8) must be lit.
Please follow the guidelines in the "Setting the time of day" section.
Selecting a cooking function and temperature
Selecting manual operation mode
After your appliance is connected to your mains supply for the first time, the numbers
on the timer display will flash. Before you can select a cooking function or set a
temperature, you must set the appliance into "manual operation" mode.
• To select manual operation mode, press the manual button (12) on the control
panel.
EN
45