Closing The Injection Gun - MS Schippers 1406500 Mode D'emploi

6. Clean the shells with soap, water and paper towels. It is OK to submerge shells. Take
care not to lose any of the small parts.
7. Dry the parts thoroughly. The plastic shells need not be completely dry.

4.6.9 Closing the injection gun

1. Place the right-hand shell on the surface. This is the side with the holes for the
screw heads.
2. Insert the spring and bush into the plastic shell.
Position the trigger lock as shown.
3. Hold the lock in this position with one hand; with your other hand, move the spring
to the position shown below. This can be difficult and may take a number of
attempts.
The correct spring position is as shown in the picture.
53