LawnMaster GT1313 Manuel De L'opérateur page 4

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

GENERAL SAFETY RULES
ADDITIONAL SAFETY INSTRUCTIONS FOR YOUR GRASS TRIMMER
Do not expose to moisture.
Use only on AC mains supply voltage shown on the product rating label.
Avoid operating your trimmer in wet grass, where feasible.
Take care in wet grass, you may lose your footing.
On slopes, be extra careful of your footing and wear nonslip footwear.
Do not walk backwards when trimming, you could trip. Walk never run.
Switch off before pushing the trimmer over surfaces other than grass.
Never pick up or carry a trimmer by the cable.
Do not lean over the trimmer guard objects may be throw by the cutting line.
Keep all nuts, bolts and screws tight to be sure the trimmer is in safe working condition.
To avoid the risk of injury keep fingers and hands clear of the line cutter on the leading edge of
the guard.
MAINTENANCE
After use, disconnect the machine from the mains and check for damage
When not in use store the machine out of the reach of children
Mains powered trimmers should only be repaired by an authorised repairer
Use only manufacturers recommended replacement parts and accessories.
The preparation for use, operation and maintenance of the appliance:
- Read the instructions carefully;
- Be familiar with the controls and proper use of the equipment;
- Before use check the supply and extension cord for signs of damage or ageing,
- If the cord becomes damaged during use, disconnect the cord from the power supply
immediately.
DO NOT TOUCH THE CORD BEFORE DISCONNECTING THE SUPPLY;
- Do not use the lawn trimmer (edge trimmer), if the cords are damaged or worn.
WARNING
- Cutting elements continue to rotate after the motor is switched off;
- Keep extension cords away from cutting elements;
- It is recommended that appliances should be supplied via a residual
current device (RCD) with a tripping current of not more than 30mA.
4

Publicité

Table des Matières
loading

Table des Matières