Assembly - LawnMaster GT1313 Manuel De L'opérateur

ASSEMBLY

WARNING
Before assembly, make sure that the grass trimmer is switched off and
unplugged.
Fitting the guard (See Figure 2 & Figure 3.)
1. Secure the guard with 3 screws.
2. Place the safety guard onto the motor housing as shown, pivot the guard anti-clockwise to the
position of figure 3. Secure the guard with the screw.
WARNING
Never use the grass trimmer unless the guard is properly fitted.
Fitting the secondary handle (See Figure 4 & Figure 5.)
1. Place the handle on the grass trimmer as shown.
2. Adjust the handle to the most comfortable position. Use the marking as a guide.
3. Pass the bolt through the secondary handle and the main handle.
4. Screw the nut into the other side of the bolt. Do not over tighten the bolt.
Fig. 2
Fig. 4
10
Fig. 5