Operating Sequence - Zanussi ZWF 1650 Notice D'utilisation

Operating sequence

Before washing your first load of laundry, we
recommend that you run a cotton cycle at 95°C,
with the machine empty, in order to remove any
manufacturing residue from the drum and tub.
Pour half a measure of detergent into the main wash
compartment and start up the machine.
1. Place the laundry in the drum
Open the door.
Place the laundry in the drum, one item at a time,
shaking them out as much as possible.
Close the door.
P0004•N
2. Measure out the detergent
Pull out the dispenser drawer until it stops. Measure
out the amount of detergent recommended by the
manufacturer in a graduated cup and pour it into the
main wash compartment
If you wish to carry out the prewash, pour detergent
into the appropriate compartment marked
3. Measure out the additive
If required, pour fabric softener into the
compartment marked
«MAX» mark.
P1218
.
.
, without exceeding the
P1219
4. Switch the machine on
Depress the On/Off button to switch the appliance
on.
The display light up and will showsthe message
«Select a programme» unless the programme has
been erased by pressing three times the Cancel
button at the end of the previous washing cycle.
On/Off
Switching the machine on for the first time
LANGUAGE
When switching on the appliance for the first time
you must set the language in which you want the
indicators in the display to appear.
Important!
If the display is not showing any language, the
appliance has already been switched on once. In
such case, go to the chapter «Language» if you
would like to change the language setting.
Example:
1. Press the Change button until the desired
language appears in the display.
Language
ENGLISH
Temp. Spin Options Change Cancel
2.Press the Cancel button to confirm the selection.
Einstellungen
Temp. Spin Options Change Cancel
B
97
Select a programme
Temp. Spin Options Change Cancel
Sprache
DEUTCH
Temp. Spin Options Change Cancel
A