Something Not Working - Zanussi ZWF 1650 Notice D'utilisation

Something not working?

Problems which you can resolve yourself.
During machine operation it is possible that one of the following messages appears on the display and at the
same time an acoustic signal will sound:
Problem with the water supply ......"No incoming water. Check tap & hose"
Problem with water draining .........."No drain. Check drain hose /filter"
Door open ......................................"Door not closed. Please check"
Once the problem has been eliminated, press the START/PAUSE button
all checks, the problem persists, contact your local Service Centre.
Problem
• The machine does not start up:
• The machine does not fill:
• The machine fills then empties
immediately:
• The machine does not empty and/or
does not spin:
• There is water on the floor:
to restart the programme. If after
Possible cause
• The door is not firmly closed.(Door not closed.
Please check)
• The machine is not plugged in or there is no power
at the socket.
• The main fuse has blown.
• The Start/Pause button has not been depressed.
• The Delay Start option has been selected.
• The water tap is closed. (No incoming water.
Check tap & hose)
• The inlet hose is squashed or kinked. (No
incoming water. Check tap & hose)
• The filter in the inlet hose is blocked. (No
incoming water. Check tap & hose)
• The door is not properly closed. (Door not
closed. Please check)
• The end of the drain hose is too low. Refer to
relevant paragraph in "water drainage" section.
• The drain hose is squashed or kinked.
• The RINSE HOLD option
NO SPIN «O» has been selected.
• The drain pump is clogged. (No drain. Check
rain hose /filter)
• Too much detergent or unsuitable detergent
(creates too much foam) has been used.
• Check whether there are any leaks from one of the
inlet hose fittings. It is not always easy to see this
as the water runs down the hose; check to see if it
is damp.
• The drain hose is damaged.
• The cap on the emergency emptying hose has not
been replaced after cleaning the filter.
• The pump has not been fully screwed in after
cleaning.
105
, NIGHT CYCLE or