Zanussi ZWF 1650 Notice D'utilisation page 106

Problem
• Unsatisfactory washing results:
• Water is not visible in the machine:
• Spinning starts late or the machine
does not spin:
• The machine vibrates or is noisy:
• The door will not open:
• The machine makes an unusual noise:
If you are unable to identify or solve the problem,
contact our service centre. Before telephoning,
make a note of the model, serial number and
purchase date of your machine: the Service Centre
will require this information.
Possible cause
• Too little or too much detergent has been used.
• An unsuitable detergent has been used.
• Stubborn stains have not been treated prior to
washing.
• The correct programme/temperature was not
selected.
• Excessive laundry load.
• The machine, which is the result of modern
technology, runs in a very economical way with
low water consumption. Performance is
nevertheless excellent.
• The electronic unbalance detection device has cut
in because the laundry is not evenly distributed in
the drum. The laundry is redistributed by reverse
rotation of the drum. This may happen several
times before the unbalance disappears and
normal spinning can resume. If, after 10 minutes,
the laundry is still not evenly distributed in the
drum, the machine will not spin. In this case,
redistribute the load manually and select the spin
programme.
• The transit bolts and packing have not been
removed.
• The support feet have not been adjusted.
• The laundry is not evenly distributed in the drum.
• Maybe there is very little laundry in the drum.
• The water level is above the bottom edge of the
door.
• The machine is heating the water.
• The drum is turning.
The door could be opened only when «Door
openable» message appears in the display and
the door locked light has gone off.
• The machine is fitted with a commutator motor
which improves machine performance.
Mod. ..........
Prod. No. ...........
Ser. No. .........
P0042•N
106