Publicité
Les langues disponibles
Les langues disponibles
not rub or interfere with movements of remote
control components.
1. Trunnion pockets
Apply Triple-Guard grease to assembly screws.
Install cover and screws. Tighten screws
securely
Check operation and movement of control lever.
Make sure remote control's shift and throttle
functions operate smoothly. Refer to REMOTE
CONTROL OPERATION TEST.
Install Throttle Friction Adjustment Screw
Install the throttle friction adjustment screw to the
brake shoe. Refer to Control Handle Friction
Adjustment.
1
1. Throttle friction adjustment screw
NOTICE
Use caution while handling the
remote control when the throttle friction
adjustment screw is assembled. Do not
bump, bend, or apply direct pressure to the
screw. This may cause the friction brake
1
shoe to dislodge and restrict throttle move-
ment.
Fasten Remote Control to Boat
Position
remote
surface. Align mounting plate with remote
control. Install four washers and screws and
tighten screws to 35 in./lbs.(4 N·m)
006377
Align mounting plate with holes and secure to
mounting surface. Use bolts and nuts if surface
thickness is less than 0.8 in. (20mm) thick and
screws for surface thicknesses between 0.8
(20mm) and 1.2 in. (30mm) thick. Tighten screws
006372
or bolts and nuts to 53-71 in./lbs.(6-8 N·m).
IMPORTANT: Make sure remote control as-
sembly is secure and does not move during op-
eration.
006360
control
behind
mounting
006340
006341
9 of 20
Publicité
