Publicité
Les langues disponibles
Les langues disponibles
Position neutral switch wire in opposite position
of remote control housing.
Install dwell plate retainer and screws.
See "Install Remote Control Cables" on
page 8.
MAINTENANCE
A CAUTION
Inspection and maintenance must be per-
formed with outboard stopped. Discon-
nect emergency stop lanyard, disconnect
battery cables, and remove spark plug
wires from spark plugs and/or disconnect
crankshaft position sensor (CPS) connec-
tor to prevent accidental starting of out-
board.
Check mounting of remote control. Tighten
screws or secure as needed.
006347
While turning propeller, check for smooth and
correct operation of remote control. Observe
linkages at outboard and be sure shift and
throttle linkages move accurately and completely
for each remote control setting.
006355
If an abnormal condition is found, repair as
needed. Replace all damaged parts. Recheck
operation of remote control after servicing.
Remote control must shift smoothly and
accurately into FORWARD, NEUTRAL, and
REVERSE, and throttle must move smoothly
through the entire throttle range from IDLE to
FULL
THROTTLE
operation in both FORWARD and REVERSE.
Check remote control for looseness, damage,
and corrosion. Clean and replace parts as
needed.
Use Triple-Guard grease to lubricate all moving
mechanisms and remote control cables.
006353
006342
(WOT).
Check
throttle
005509
15 of 20
Publicité
