Publicité
Les langues disponibles
Les langues disponibles
Determine Remote Control Cable Length
Measure from center of control handle with
remote control in mounting position, along
intended cable route to engine centerline at
transom height as illustrated by dotted lines in
diagram. Add 40 in. (1.0 m) to the measurement.
This dimension is the required cable length.
Evinrude/Johnson Genuine Parts outboard con-
trol cables are available in one-foot increments
from 5 ft. to 20 ft. lengths and two-foot incre-
ments from 20 ft. to 50 ft. lengths. Use cables
that are equal to your calculated length, or are
the next longer available length.
IMPORTANT: Route cables with fewest number
of bends. Bends must never be less than 6 in.
(150 mm) radius.
Install Remote Control Cables
®
Use Triple-Guard
grease to lubricate all moving
mechanisms, trunnion pockets, and remote
control cables.
A WARNING
Always use new cotter pins and bend both
sides of cotter pin as shown to prevent
interference with remote control housing
or possible dislodging of cotter pin from
mounting pin.
8 of 20
Install shift cable and flat washer on to shift pin
and secure with new cotter pin. Bend cotter pin
as shown.
1. Shift cable
IMPORTANT: Use Evinrude/Johnson Genuine
Parts or parts with equivalent characteristics, in-
cluding type, strength, and material.
Foot Throttle Note: If foot throttle will be in-
stalled, install trunnion, P/N 126034 as a spacer,
in place of the throttle cable.
006152
1. Trunnion, P/N 126034
Install throttle cable and flat washer on to throttle
pin and secure with new cotter pin. Bend cotter
pin as shown.
004910
1. Throttle cable
Make sure shift and throttle cables are in
trunnion pocket(s), and safety switch wiring does
1
006375
1
DCS1085
DSC1086
1
006376
Publicité
