Publicité
Les langues disponibles
Les langues disponibles
Cut Mounting Holes
IMPORTANT: Make sure the selected mounting
location has all the required clearances before
drilling or cutting. Disconnect battery to prevent
accidental shock from electrical wiring.
Use "DRILL TEMPLATE - CONCEALED SIDE
MOUNT REMOTE CONTROL" on page 19 for
cutting mounting holes.
Remote control comes from factory in starboard
side mounting configuration. Port side mounting
requires reconfiguration of remote control. Refer
to "Port Side Mounting" on page 12.
If remote control must be mounted at a 30° angle
above or below the standard horizontal mounting
position, rotate template 30° in the required
direction.
30°
Position template on mounting surface. Mark the
centers of all drill locations.
Cut along the outer line of shaded area. Use
appropriate cutting tools. A 2 7/8 in.(73mm) hole
saw can be used for main through hole. Notch
bottom of hole for trim and tilt wiring. Drill ONLY
one 1/2 in. (12 mm) hole at upper location. Refer
to diagram below and "DRILL TEMPLATE -
CONCEALED
CONTROL" on page 19.
3
1
30°
1. Shaded area
2. Drill for STARBOARD side mounting ONLY
3. Drill for PORT side mounting ONLY
Select proper fasteners and drill bit size. Deter-
mine thickness of mounting surface.
• Less than 0.8 in. (20 mm) thickness: Drill
006305
three (3) 9/32 in. (7 mm) diameter holes to
use 8 mm bolts and nuts and washers
provided.
• 0.8 in. - 1.2 in. (20 - 30mm) thickness: Drill
three (3) 1/8 in. (3 mm) holes to use screws
provided.
Drill three holes at mounting hole locations.
006338
SIDE
MOUNT
REMOTE
2
006303
006339
7 of 20
Publicité
