Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION INSTRUCTIONS
Read and familiarize yourself with the complete
installation instructions of the remote control
before attempting to install the remote control.
Always test operation of remote control once
installed.
A WARNING
Failure to properly install and test remote
control may result in remote control mal-
function and loss of control of boat.
IMPORTANT: Refer to specific outboard instal-
lation instructions for information related to con-
necting remote controls to outboard.
Mounting Location
Select the appropriate location based on boat
configuration.
2
1
1. Port side (See Port Side Mounting instructions)
2. Starboard side
IMPORTANT: The mounting location must be a
flat surface and must be strong enough to pro-
vide a rigid support. Strengthen mounting sur-
face as necessary. Remote control cannot be
installed if thickness of mounting surface ex-
ceeds 1.2 in. (30 mm).
Refer
to
"PROFILE
CONCEALED
SIDE
CONTROL"
on
page 17
TEMPLATE - CONCEALED SIDE MOUNT
REMOTE CONTROL" on page 19.
Place remote control at proposed location and
check clearance around remote control handle at
full throttle in FORWARD and then at full throttle
in REVERSE. There must be at least 4 in.
(102 mm) of clearance between the handle and
6 of 20
006151
DIMENSIONS
-
MOUNT
REMOTE
and
"DRILL
any part of the boat throughout the control
handle travel.
1
1. 4 in. (102 mm) clearance line
There must be at least 18 in. (457mm) of clear
space from center of remote control handle for
cable routing. Control cables must be straight as
they exit the remote control. Allow at least 6 in.
(152 mm) to the beginning of the first bend of
control cables.
18 in. / 457 mm
The remote control can be mounted at a 30°
angle above or below the standard horizontal
mounting position.
006160
006279
30°
30°
006304
Publicité
