GYS TITAN 400 DC Mode D'emploi page 35

Torch double button +
potentiometer
REMOTE CONTROL
The remote control operates in TIG mode and in MMA.
ref. 045699
Connection :
1- Plug the remote control into the connection at the back of the machine.
2- The interface will detect automatically the remote control and open a selection menu :
Pressing the scroll wheel validates the choice of type of remote controller and allows to go back to stand-by mode.
Connection
The TIG 300 DC is equipped with a female socket for a remote control.
The specific 7 pin male plug (option ref.045699) enables connection to the different types of manual remote control or foot pedal. For the cabling
layout, please see the diagram below.
TYPE DE COMMANDE À DISTANCE
CONNECT-5
Operating :
• Manual remote control (option ref. 045675).
The remote control enables the variation of current from 50% to 100% of the set intensity In this configuration, all modes and functions of the
machine are accessible and can be set.
• Foot pedal (option ref. 045682) :
The pedal control enables variation of the current from the minimum current to 100% of the set intensity.
In TIG, the welding machine only operates in 2T mode. The upslope and downslope are not automatically managed by the current source, and are
controlled by the user with the foot pedal.
TITAN 400 DC
Torch type
Torch double button
G
F
A
B
E
D C
External view Electric diagram according to the remote control type.
A command is shown but not active.
Remote control with potentiometer selection.
Remote control with potentiometer selection.
Commande à distance
Pédale
Torch with trigger
D
045682
C
B
045675
A
Désignation du fil
Curseur
manuelle
Commun/Masse
Switch / Interrupteur
AUTO-DETECT
ARC ON
Wire description
Common/Earth
Button 1
Button 2
Common/Potentio-
meter earth
10 V
Cursor
Pin du connecteur
associée
10 V
REG I
EN
Pin
2 (green)
4 (white)
3 (brown)
2 (grey)
1 (yellow)
5 (pink)
A
B
C
D
E
F
G
35