• MMA PULSE
The MMA Pulsed mode is recommended for vertical-up welding (PF). The pulse mode keeps the weld pool cold and eases the transfer of matter. Wit-
hout the pulse mode, vertical-up welding requires a difficult «Christmas tree» shape triangular movement. With the MMA Pulsed mode, this movement
is no longer required and a simple straight up movement is enough (depending on the thickness of the workpiece). If you wish to widen your weld
pool, a simple lateral movement is enough (similar to normal welding).
In this case the pulse current frequency can be adjusted on the display. This process allows greater control during vertical-up welding.
Adjustable values
Recommendations:
• Low Hot start, for thin sheets, high Hot start for difficult-to-weld metals (dirty or oxidised).
• The Arc Force is set between -10 and +10. It needs to be combined with the choice of type of electrodes selected in the Advanced Menu (refer to
Advanced Menu section).
MMA - ADVANCED MENU
It is possible to access the end of welding cycle settings.
Access to these advanced parameters is possible via the menu
Using the scroll-wheel, the available advanced settings are :
Parameter
Description
Type
of electrode
HotStart
duration
Anti Sticking
TUNGSTEN ELECTRODE WELDING WITH INERT GAS (TIG MODE)
CONNECTIONS AND RECOMMENDATIONS
• The TIG DC welding requires gas shield protection of pure gas (Argon).
• Connect the earth clamp to the positive connector (+). Connect the power cable to the negative plug (–), as well as the torch and the gas connec-
tions.
• Ensure that the torch is equipped and ready to weld, and that the consumables (Vice grip, ceramic gas nozzle, collet and collet body) are not
damaged.
28
TITAN 400 DC
I
A
A
t(s)
%
-
TIG HF
TIG
lift
MMA
PULSE
2T
4T
4T
LOG
Process MMA PULSE
The grey areas are not useful for this mode.
HotStart
0 - 100%
Setting
STD
PULSE
rutile
X
X
basic
cellulosic
0 - 2s
X
X
ON - OFF
X
X
MADE IN FRANCE
%I
A
%t
H z
V
Hz
I
kJ
+
JOB
setup
OK
E. TIG
%I
SPOT
TACK
PULSE
Cold current/Back-
Arc Force
ground current)
-10 à +10
+20 - +80%
The type of electrodes determines the specific settings and has to do with
the type of coating used to improve the quality of the weld.
The duration of the HotStart can be adjusted to make the arcing easier
when using difficult electrodes.
The anti-sticking feature is recommended to safely remove the electrode in
case it is stuck to the metal.
Pulse frequency
0.4 - 20 Hz
.
Recommendation
EN