Publicité
Les langues disponibles
Les langues disponibles
Current threshold when
the weld stops.
I Stop
Time threshold when the
weld stops.
t Stop
Pulse with wave shape.
Shape
(wave shape)
Pulse current spot wel-
ding duration.
t Pulse
Spot welding duration in
continuous current.
t Continuous
COMPATIBLE TORCHES
Trigger
L
For the 1 button torch
DB
For the 2 buttons torch
2T MODE
P
t
t
t
Main button
Main button
T1
T1
Main button
T1
4T MODE
t
t
t
Main button
T1
T2
Main button
T1
T2
Main button
T1
T2
4T MODE log
t
t
t
Main button
Main button
T1
T1
T2
T2
Main button
T1
T2
or
or
or
Secondary button
Secondary button
Secondary button
32
10% - 100%
0s - 10s
Square
Sinus
Triangle
Trapeze
Manual,
0.1s – 10s
Manual,
0.1s – 10s
L
Double Button
DB
, the button is called «main button».
, the first button is called «main button» and the second button is called «secondary button».
t
t
t
T2
T2
T2
t
t
t
T3
T3
T4
T3
<0.5s
<0.5s
>0.5s
<0.5s
<0.5s
<0.5s
<0.5s
>0.5s
t
T3
T3
TITAN 400 DC
X
X
X
X
X
X
Double Button + Potentiometer
P
T1 - The main button is pressed, the welding cycle starts (PreGas,
I_Start, UpSlope and welding).
T2 - The main button is released, the welding cycle is stopped (DownS-
lope, I_Stop, PostGas).
For the double button torch and in 2T mode only, the secondary button
works like the main button.
T1 - The main button is pressed, the cycle starts at PreGas and stops
in the I_Start phase.
T2 - The main button is released, the cycle continues in UpSlope and
in welding.
T3 - The main button is pressed, the cycle switches to DownSlope and
stops in I_Stop.
T4 - The main button is released, the cycle ends with PostGas.
Nb : for torches, double button and double button with potentiometer
=> command « up/welding current » and active potentiometer, com-
mand «low » inactive.
T4
T4
T1 - The main button is pressed, the cycle starts at PreGas and stops
>0.5s
in the I_Start phase.
T2 - The main button is released, the cycle continues in UpSlope and
in welding.
LOG : this mode is used during welding :
t
- A brief press of the main button (<0.5s), the current switches from I
t
welding current to I cold and vice versa.
- the secondary button is kept pressed, the welding current switches
from I welding current to I cold
- the secondary button is kept released, the welding current switched
T4
T4
T4
T3
from I cold to I welding current.
T3 - A long press on the main button (>0.5s), the cycle switches to
DownSlope and stops in the I_Stop phase.
T4 - The main button is released, the cycle finishes with PostGas.
This current threshold is a phase before the
current upslope.
The square wave shape is the traditional
shape for PULSE welding but it is noisy in high
frequency. Other shapes can be used to adapt
the penetration and the noise level.
X
The spot welding times allow to define a spot
that can be reused over time.
L
X
DB
P
EN
Publicité
