How To Fill / Empty The Tank - Skandika NEMO IV Instructions De Montage Et Mode D'emploi

How to fill / empty the tank

1. Remove the Fill Plug (#50) from the Upper Tank (#24).
2. To fill tank with water, refer to Fig. A. Insert the Funnel (#52) into the tank, then use
a cup or the Pumping siphon (#53) and a bucket to fill the tank. Use the water level
gauge on the side of the tank to measure desired water level in the tank.
3. To empty the tank, refer to Fig. B. Place a bucket next to the rower, and use the
Pumping siphon (#53) to pump out the water from the tank into the bucket.
4. Insert the Fill Plug (#50) into the Upper Tank. Wipe excess water off of the frame.
NOTES:
• Fill the tank only with tap water. Add 1 water-purification tablet (1 packet is inclu-
ded.). Never use pool chlorine or chlorine bleach. This will damage the tank and
void the warranty.
• Add a water purification tablet every 6 months or as needed. If water remains clou-
dy, replace the water in the tank.
• Water from the tank is not suitable for consumption. Dispose of the water after
pumping it out from the tank.
The water level
• See Fig. A: The water level gauge is on the side of the tank. The maximum fill level
is 6. Never overfill the tank over this limit! Filling the tank over this limit will void
the warranty.
• The resistance depends on the water level in the tank. Water level 1 is the lowest
resistance. Level 6 is the highest resistance.
Water level label
29