Control Panel - VWR 444-0756 Manuel D'instruction

D.
r /W C P
oCker aver ontrol anel
The front panel of the Rocker/Waver contains all the controls and displays needed
to operate the unit.
A. Standby button/standby indicator light: The standby indicator light will
illuminate when the unit is plugged in. The unit will be in standby mode. Press
the standby button to activate the speed/tilt and time functions. The standby indica-
tor light will shut off and the speed/tilt display and time display will illuminate.
Press the standby button again and the unit will once again be in standby
mode.
B. Speed/tilt display: Displays the speed and tilt of the unit. C. Up/down arrows
for set-point control. On/off button starts/stops the rocking/waving function.
D. The speed/tilt indicator light will be illuminated when the unit is rocking/waving.
F. g. B. H.
E. C. I.
E. Function button: Press to choose the function you are setting: speed or tilt.
F. Speed indicator light: Illuminates when the speed is displayed.
g. tilt indicator light: Illuminates when the tilt angel is displayed.
H. time display: Displays accumulated time (continuous mode) or how much
A.
time is remaining (timed mode). I. Up/down arrows for set-point control. On/
off button starts/stops the time function. The display range is from 0 to 9999
minutes in one (1) second increments. The display will indicate minutes and
seconds until the timer reaches 99 minutes and 59 seconds (99:59), then the
display will automatically display minutes up to 9999.
EN
4