Charging The Rb 1 Battery Pack (Rechargeable Battery); Changing The Rb 1 Battery Pack In The Wireless Controller; Intended Use; Use - VWR VOS 60 control Mode D'emploi

• Charging the RB 1 battery pack (rechargeable battery)

The battery pack of the Wireless Controller can be charged by any of the following means:
- on the VOS 60 control station
- via a USB cable at the PC or station
- via an OS 1.0 power supply unit.

• Changing the RB 1 battery pack in the Wireless Controller

Please comply with the relevant safety instructions in the "Safety instructions" section
DANGER
for the RB 1 battery pack!

Intended use

• Use

For mixing/stirring liquids with low and high viscosities by various stirring tools.
Intended use: Stand device (chuck points down).

• Range of use (indoor use only)

- Laboratories
- Pharmacies

• Wireless remote control

Before using the wireless link between the Wireless Controller (WiCo) and the laboratory device, first check whether your
region is included in the radio communications approval for the device. If it is not, remote control can also be performed
using a USB cable.
This instrument is suitable for use in all areas except:
- Residential areas
- Areas that are connected directly to a low-voltage supply network that also supplies residential areas.
The safety of the user cannot be guaranteed:
- If the instrument is operated with accessories that are not supplied or recommended by the manufacturer
- If the instrument is operated improperly or contrary to the manufacture's specifications
- if the instrument or the printed circuit board are modified by third parties.

Explication of warning symbols

DANGER
WARNING
CAUTION
- Schools
- Universities
General hazard
This symbol identifies information that is of vital importance for safeguarding your health
and safety. Disregarding this information can lead to health impairment and injuries.
This symbol identifies information that is of importance for the technically correct
functioning of the system. Disregarding this information can result in damage to the
instrument or to system components.
This symbol indicates information which is important for ensuring that the operations
of the instrument are performed efficiently and for using the instrument. Failure to
observe this information can result in inaccurate results.
11