Safety Instructions; Warning; Standards & Regulations - VWR 444-0756 Manuel D'instruction

s I
afety nstrUCtIons
Please read the entire instruction manual before operating the Rocker/Waver.
WARNINg! DO NOt use the Rocker/Waver in a hazardous atmosphere or
with hazardous materials for which the unit was not designed. Also, the
user should be aware that the protection provided by the equipment may
be impaired if used with accessories not provided or recommended by
the manufacturer, or used in a manner not specified by the manufacturer.
Always operate unit on a level surface for best performance and maximum
safety.
DO NOt lift unit by the platform tray or lid.
CAutION! To avoid electrical shock, completely cut off power to the unit by
disconnecting the power cord from the unit or unplug from the wall outlet.
Disconnect unit from the power supply prior to maintenance and servicing.
Spills should be removed promptly. Biohazard spills should be cleaned
up using approved laboratory procedures. Solvent spills are a fire haz-
ard. Stop the unit immediately, and DO NOt operate until clean up is
complete and vapors have dissipated (motor brushes arc and may ignite
flammable vapors).
DO NOt immerse the unit for cleaning.
DO NOt operate the unit if it shows signs of electrical or mechanical damage.
Earth Ground - Protective Conductor Terminal
Alternating Current
3
s & r
tandards egUlatIons
VWR International hereby declares under its sole responsibility that the products
comply with the requirements of the following directives and associated standards:
Associated Eu guidelines:
EMC directive 2004/108/EC
LVD directive 2006/95/EC
Safety standards:
IEC 61010-1 Safety requirements for electrical equipment for
measurement, control and laboratory use. Part I: General
Requirements.
IEC 61010-2-010* Part II: Particular requirements for laboratory equipment
for the heating of materials.
IEC 61010-2-051 Part II: Particular requirements for laboratory equipment
for mixing and stirring.
UL Std. No. 61010-1
CSA/CAN C22.2 No. 0-M91
CSA/CAN C22.2 No. 61010-1-04
EMC standards:
EN61000-3-2 EN61000-4-3
EN61000-3-3 EN61000-4-4
EN61000-4-5 EN61000-4-6
EN61000-4-2 EN61000-4-11
* Applies to Incubating Rockers/Wavers only
EN