Maintenance & Servicing; Intended Use; Equipment Disposal; Environmental Conditions - VWR 444-0756 Manuel D'instruction

M & s
aIntenanCe ervICIng
The Rocker/Waver is built for long, trouble-free, dependable service. No lubrication
or other technical user maintenance is required. It needs no user maintenance
beyond keeping the surfaces clean. The unit should be given the care normally
required for any electrical appliance. Avoid wetting or unnecessary exposure to
fumes. Spills should be removed promptly. Do not use a cleaning agent or sol-
vent on the front panel which is abrasive or harmful to plastics, nor one which is
flammable. Always ensure the power is disconnected from the unit prior to any
cleaning. If the unit ever requires service, contact your VWR representative.
I U
ntended se
These Rockers and Wavers are intended for general laboratory use.
e d
qUIPMent IsPosal
This equipment must not be disposed of with unsorted waste. It is your
responsibility to correctly dispose of the equipment at life-cycle-end
by handing it over to an authorized facility for separate collection and
recycling. It is also your responsibility to decontaminate the equipment in
case of biological, chemical and/or radiological contamination, so as to
protect the persons involved in the disposal and recycling of the equip-
ment from health hazards.
For more information about where you can drop off your waste of equipment, please
contact your local dealer from whom you originally purchased this equipment. By
doing so, you will help to conserve natural and environmental resources and you will
ensure that your equipment is recycled in a manner that protects human health.
e C - o
nvIronMental ondItIons
Operating Conditions: Indoor use only.
Temperature*: For use in CO2 environments, incubators or cold rooms
ranging from -10 to 60°C
Humidity: 80% relative humidity, non-condensing
Altitude: 0 to 2000 M above sea level
Non-Operating Storage:
Temperature*: -20 to 65°C
Humidity: maximum 80% relative humidity, non-condensing
Installation Category II and Pollution Degree 2 in accordance with IEC 664.
* Avoid cold starts: Unit is not designed to start after being in a cold room
environment. Bring unit into cold room from a room temperature environment,
operate and remove unit from cold room as soon as operation is complete.
e C - I
nvIronMental ondItIons
Operating Conditions: Indoor use only.
Temperature: 5 to 40°C
Humidity: 80% relative humidity, non-condensing
Altitude: 0 to 2000 M above sea level
Non-Operating Storage:
Temperature: -20 to 65°C
Humidity: maximum 80% relative humidity, non-condensing
Installation Category II and Pollution Degree 2 in accordance with IEC 664.
a r W
Pen Ir oCkers and avers
r W
nCUbatIng oCkers and avers
EN
2