VWR 444-0756 Manuel D'instruction page 10

r /W o
oCker aver PeratIng
5. Setting timed mode: Programmed time.
a. Press the up/down arrows below the time display until you reach the desired
time.
b. Start this function by pressing the on/off button below the time display. The unit
will run for the selected time, the up/down arrows will become inactive while the
timer is running. The unit will stop rocking/waving when time display reaches zero
(0:00). Four (4) audible beeps will indicate the time down function is complete. The
time display will default back to the set time. To repeat for the same time, simply
depress the on/off button again.
c. To interrupt an automatic timing cycle before it is completed, press the on/off
button below the time display. The time display will flash off and on to indicate
the time function is on "hold". IMPORtANt: This will NOt interrupt the rocking/
waving function. Press the on/off button below the speed/tilt display to interrupt
the rocking/waving function. Restart the timer by pressing the on/off button
below the time display. Unit will continue counting down to zero (0:00). When
the display reaches zero (0:00), you will hear the four (4) audible beeps that indicate
the time down function is complete and the rocking/waving function will cease.
6. turning unit off:
a. To turn the unit off, press the standby button. The speed/tilt and time displays
will be blank, the standby indicator light will illuminate. The Rocker/Waver
should be kept in standby mode when not in use. To completely cut off power
to the unit, disconnect the power cord from the unit or un-plug from the wall
outlet.
9
I ( ' )
nstrUCtIons Cont d
OPERAtINg tIPS
Built-in memory maintains the last used speed/tilt and time settings during a power
interruption.
A built-in program will shut power off to the motor if the platform tray is prevented from
rocking/waving, or the unit is overloaded beyond it's recommended weight capacity.
EN