VWR 444-0756 Manuel D'instruction page 12

I r /W
nCUbatIng oCker aver
d. To stop rocking/waving function, press the on/off button below the speed/tilt
display. The unit will complete one full rotation then stop in the horizontal
"home" position. The speed indicator light will flash until the rotation is
complete. When the cycle is complete, the unit will automatically move to
standby mode and the standby indicator light will illuminate.
OPERAtINg tIPS
When the unit is running at slow speeds or high angles, making large changes to the
tilt angle or speed may take several minutes to complete. The quickest way to make
large changes to the speed or tilt angle is to stop the unit, change the speed or tilt
angle, then restart by pressing the on/off button below the speed/tilt display.
5. Setting time to zero (0:00) and continuous mode: Accumulated time.
a. Press and hold the on/off button below the time display. After three (3) seconds,
the display will indicate the previous set time.
b. Simultaneously press both the up and down arrows, the display will indicate
zero (0:00). The unit time is now set to zero (0:00) minutes. Alternately, you can
use the up/down arrows to get to zero (0:00).
c. Press the on/off button below the time display. The display will indicate the
accumulated time. The up/down arrows will become inactive. To stop timer,
press the on/off button again. IMPORtANt: This will NOt interrupt the
rocking/waving function. Press the
to interrupt the rocking/waving function.
d. To re-set, press and hold the on/off button below the time display. After three
(3) seconds, the display will indicate the previous set time, which was zero
(0:00).
6. Setting timed mode: Programmed time.
a. Press the up/down arrows below the time display until you reach the desired
time.
11
o I (
PeratIng nstrUCtIons Cont
on/off button below the speed/tilt display
' )
d
b. Start this function by pressing the on/off button below the time display. The
unit will run for the selected time, the up/down arrows will become inactive
while the timer is running. The unit will stop rocking/waving when time display
reaches zero (0:00). Four (4) audible beeps will indicate the time down function
is complete. The time display will default back to the set time. To repeat for the
same time, simply depress the on/off button again.
c. To interrupt an automatic timing cycle before it is completed, press the on/
off button below the time display. The time display will flash off and on to
indicate the time function is on "hold". IMPORtANt: This will NOt interrupt the
rocking/waving function. Press the on/off button below the speed/tilt display
to interrupt the rocking/waving function. Restart the timer by pressing the on/
off button below the time display, unit will continue counting down to zero
(0:00). When the display reaches zero (0:00), you will hear the four (4) audible
beeps that indicate the time down function is complete and the rocking/waving
function will cease.
7. turning unit off:
a. To turn unit off, press the standby button. The temperature, speed/tilt and time
displays will be blank, the standby indicator light will illuminate. The Incubating
Rocker/Waver should be kept in standby mode when not in use. To completely
cut off power to the unit, disconnect the power cord from the unit or un-plug
from the wall outlet.
OPERAtINg tIPS
Built-in memory maintains the last used temperature, speed/tilt and time settings
during a power interruption.
A built-in program will shut power off to the motor if the platform tray is prevented
from rocking/waving, or the unit is overloaded beyond it's recommended weight
capacity.
EN