Squeegee Replacement; Squeegee Angle Adjustment - Nilfisk BA 500 Mode D'emploi

Squeegee Replacement

If the squeegee leaves narrow streaks of water, it is probably dirty or damaged. Remove the squeegee, rinse it under warm water and inspect
the rear squeegee blade. Reverse or replace the squeegee blade if it is cut, torn, wavy or worn to a radius.
To Reverse or Replace the Squeegee Blade...
1 Raise the squeegee.
2 Remove the wing nuts, then unlock and remove the rear straps.
3 Remove the rear squeegee blade from the tool.
4 The rear squeegee blade has 4 working edges. Turn the blade so a sharp 90° edge points toward the front of the machine and against
the floor. Replace the blade if all edges are nicked, torn or worn to a radius.
5 Install the blade, the rear straps and the wing nuts.
Reverse or replace the front blade if cut, torn, wavy or worn to a radius.
The four wiping edges of the squeegee blade.
C
B
Rear Squeegee Blade

Squeegee Angle Adjustment

Adjust the squeegee angle whenever a blade is replaced, or if the squeegee is not wiping the floor dry.
To Adjust the Squeegee Angle...
1 Park the machine on a flat, even surface.
2 Lower the squeegee.
3 Turn the Squeegee Adjustment Knob until the rear squeegee blade touches the floor evenly across its entire width.
31
D
A
Wing Nut
Squeegee Adjustment Knob
Lock
Left Rear Strap
Right Rear Strap