Humidity Alert - Bresser Hygrometer MA Mode D'emploi

2.
3.
4.

10 Humidity alert

1.
2.
3.
4.
5.
6.
7.
26 / 60
Touch the C.F/UP or MAX.MIN/DOWN touch button to
set the desired value. Possible values: 60%, 65%, 70%
or 75%.
Touch C/F touch button again for approx. 3 seconds to
save the settings. Mould alert will be triggered if the hu-
midity will reach the set value.
"Light signal when alarm is activated" will flash and
MOULD ALERT will be displayed on the screen until
the humidity drops below the set value again.
In normal display mode, touch the SET/DEW POINT
touch button for approx. 3 seconds to switch to humid-
ity alert settings mode. Humidity upper limit display will
flash.
Touch C.F/DOWN or MAX.MIN/UP touch button to set
the desired value.
Touch SET/DEW POINT touch button to switch to hu-
midity lower limit setting.
Touch the C.F/UP or MAX.MIN/DOWN touch button to
set the desired value.
Finally touch the SET/DEW POINT touch button to exit
settings mode.
Touch the ON/OFF touch button to activate humidity
alert. ALERT will be displayed on the screen.
Touch the ON/OFF touch button again to disable the
humidity alert. ALERT will not be displayed.