Temperature And Humidity - Bresser VentAir Manuel D'instructions

temperature will be displayed on the main unit. The main unit will automatically update its readings at
about 60 second intervals.
NOTE!
When the outdoor temperature is above or below the measurement range, the display will show HHH
(high) or LLL (low).
Manual time setting and other settings
To make manual settings, proceed as follows:
1. In normal time mode press the CF/SET touch control (12b) for approx. 3 seconds to enter the settings
mode. The value to be set is flashing. Value settings order: hours > minutes > 12/24 hours > On/Off
2. Press MEM/ or CH/
3. Press CF/SET to switch to the next setting.
4. Press MEM/ or CH/
5. Press CF/SET to switch to the next setting.
6. Press MEM/ or CH/
7. Press CF/SET to switch to the next setting.
8. Press MEM/ or CH/
storage.
9. Press CF/SET to save and exit settings mode. If there is no operation for 20 seconds, the existing setting
will be saved and the device returns to normal display mode.
NOTE!
When choosing ON for 24 hour measurement data storage all stored MIN/MAX values for temperature
and humidity will be deleted daily at 0:00h! When choosing OFF the data will be stored indefinitely until
a battery change is required.

Temperature and humidity

1. Once the batteries are installed the main unit will start displaying the interior measurement information.
The main unit will display the information from the outdoor sensor for the first time approximately 3-4
minutes after the power supply was established.
2. Press CF/SET touch control (12b) to switch screen display between °C or °F. Screen display will change
for outdoor temperature as well as for indoor temperature.
Indoor humidity indicator
The indoor humidity indicator (6) displays the following conditions:
WET
WET
COMFORT Indoor humidity between 45% and 65%
COMFORT DRY
DRY
DRY WET
NOTE!
Read chapter "Ventilation indicator" for more information.
Temperature and humidity MAX/MIN records
1. Press the touch control MEM/
(MIN) and maximum (MAX) temperature and humidity. The display will change for the indoor
temperature as well as for the outdoor temperature.
2. The MIN/MAX temperature and humidity values will be recorded automatically.
NOTE!
Depending on the selected type for measurement data storage the MIN/MAX values will be saved for 24
hours or until batteries need to be changed (Read chapter "Manual time setting and other settings").
3. Press MEM/ touch control for approx. 3 seconds to delete MIN/MAX values manually.
Atmospheric change
The device uses the measurement data to calculate the absolute humidity. The icons indicate how the
ventilation would affect the indoor climate:
to set the hours for the current time.
to set minutes for the current time.
to select 12 or 24 hours time mode.
to switch between ON or OF to enable or disable 24 hour measurement data
Indoor humidity between 66% and 95%
WET
Indoor humidity between 20% and 44%
(12a) several times to switch between the values for current, minimum
12