BH LK700WS Guide D'utilisation page 28

SHUTTING DOWN THE TREADMILL
The treadmill can be shut down by turning off the power, which will not damage the treadmill.
COMMON ERRORS AND SOLUTIONS
PROBLEM
Treadmill does not work
Belt does not run properly
Belt is slipping
1. ELECTRONIC ERROR: 01
A: E01: The lower control board is having difficulty communicating with the console.
B: Solution: Check the 4 lines that connect the console and see if they are connected properly.
Check for pinched, damaged, or loose cables. Secure the cable connections if they are loose,
replace the cables if damaged.
2. ELECTRONIC ERROR: 02
A: E02: The lower control board does not detect motor voltage.
B: Solution: Check the + and - connection wires. Make sure they are connected to the + and -
terminals and that the wires are not damaged.
3. ELECTRONIC ERROR: 03
A: E03: No speed signal is detected
B: Solution: Check to see if the speed sensor is connected securely. Check to see if the sensor
is in line with the magnet on the motor and the gap between them is 3-5mm. If the problem
persists, change the speed sensor.
4. ELECTRONIC ERROR: 05
A: E05: Motor current is over limited.
B: Solution: Visually inspect the motor to see if it turns freely. Make sure that there is nothing
obstructing the movement of the running belt on rollers. If the problem persists, replace the motor.
5. ELECTRONIC ERROR: E07
A: E07: Safety key is not detected.
B: Solution: Make sure that the safety key is installed. If problem persists, replace the safety key.
28
POSSIBLE CAUSE
a. Not connected to power supply
b. Safety key not inserted
c. Signal not being received
d. Treadmill is not on
e. Fuse is broken
a. Running belt needs lubrication
b. Running belt is too tight
a. Running belt is too loose
b. Motor belt is too loose
SOLUTION
Plug into socket
Insert safety key
Check connections to lower control board
Switch on
Change the fuse
Lubricate board with silicon
Adjust running belt
Adjust running belt
Adjust the motor belt
LK700WS v.2