BH LK700WS Guide D'utilisation page 25

BUTTON DESCRIPTIONS
1. Start : Starts the treadmill, press Start again to pause the treadmill
2. Stop: Stops the treadmill.
3. Speed+: While setting a program, this button will increase a setting value and when the treadmill is
running, it is used to increase the treadmill speed.
4. Speed -: While setting a program, this button will decrease a setting value and when the treadmill is
running, it is used to decrease the treadmill speed.
5. MODE : Toggles between programs
6. Incline: Increases the desktop height
7. Incline: Decreases the desktop height
8. 1 / 2: Desktop height memory buttons – to set press one of the memory buttons for 3 seconds until
the light flashes. The custom setting will be saved. Press the memory button to return to the custom
setting.
9. Safety Key – The safety key is magnetic and will rapidly stop the treadmill when it is pulled off.
When the safety key is off the display will say E07. The treadmill will not run with the safety key off.
* Note: when moving the desktop up and down, make sure the desktop is free of unstable items they can roll off
the desktop.
Display ranges
Time (Minute: Second)
Speed(km/h) (MPH)
Distance
Calories
PACE FUNCTION CALCULATION
When user is walking on the treadmill, the pace of user will be recorded automatically by the console.
Attention: the following factors will impact the accuracy of the pace calculation: speed, weight of user
and use characteristics. For example: It's difficult to record the pace of lighter user. (User weights below
110lbs or 50kgs. Or the speed below 1MPH or 1.6KPH)
* NOTE – the maximum display range will flip to 0 after it gets to 9999.
AUTOMATIC STOP FUNCTION:
If the treadmill is not used for 30 seconds, the treadmill will stop automatically.
When the treadmill is in standby mode, press both "MODE" and "SPEED" button at the same time for
3 seconds to turn the Automatic stop function on or off. When the screen shows "on", this function is
ready, when the screen show "off", this function will not work.
Initial Set the initial value
0:00 N/A
0.0 N/A
0.0 N/A
0 N/A
Set range Display range
5:00-99:00 0:00-99:59
0.5-6.5kph
N/A
0.3-4.0mph
1.0-99.0 0.0-99.9
10-9990 0-9999
25
LK700WS v.2