all-clad NC00134439 Guide D'utilisation page 33

Problems
E0 is displayed on screen Lid temperature sensor is faulty.
E1 is displayed on screen Bottom temperature sensor is faulty. Send to repair and maintenance department.
E2 is displayed on screen. Lid is not locked.
E5 is displayed on screen. Abnormal low pressure.
Steam leaking from lid.
Possible causes
The sealing gasket was not properly
installed.
Solutions
Send to repair and maintenance department.
Check if the selected program requires the
lid totally closed. If yes, completely lock the
lid. If not, send to repair and maintenance
department.
Check that the gasket is properly installed and
cleaned. Chech that the pressure limit valve
falls down into place and is cleaned. Check that
the lid fixing nut is well tightened.
Remove the gasket, clean it and reinstall the
sealing gasket properly, in the correct position.
EN
33