all-clad NC00134439 Guide D'utilisation page 17

• Then, press the
.
• Adjust the time value by pressing the
• You can press the
does not affect the time setting as they are independent from each other.
Please note that the
• Once the settings are selected, press the
start of the preheating phase. And the display shows
• After preheating, it will beep again to indicate that cooking has begun: time will be displayed and will be
counting down.
• It is possible to change time and pressure settings during cooking: Press the
pressing the
• Once the new settings are selected, press the
audible tone).
• The remaining time will be displayed and will be counting down.
Once cooking is finished, the appliance will beep 3 times to indicate the end of cooking and
displayed on the screen.
NOTE : remains displayed during 1 minute, but at any time you can switch back to
pressing any button on the control panel.
button for time setting. The
button, in case you need to change again the pressure level. The new pressure setting
button is not active for this function.
buttons until the new time is displayed. The same can be done for the PRESSURE setting.
button will blink and a default time value will be displayed
buttons.
button to start preheating. The appliance will beep to indicate the
.
button to continue cooking (this will be signaled by an
button. Adjust the time value by
screen by
EN
will be
17