all-clad NC00134439 Guide D'utilisation page 29

Once your food is cooked, unplug the appliance to clean it :
• Clean the housing with a damp and soft cloth. Do not use abrasive sponge as it may scratch the glossy surface.
• To clean the lid : unscrew the central nut (under the lid) in anti-clockwise direction. Remove the nut and keep it
in a safe place (picture 1 on previous page). Then remove the lid and clean it under water. Dry it off thoroughly
before putting it back into place. Finally screw back the nut, taking care that it is in the correct position (the
black sealing ring must be pressed against the lid surface).
• Rinse the sealing gasket (picture 2). Dry it off thoroughly before putting it back into place. Make sure that the
gasket is correctly positioned on the metal ring.
• To clean the float valve (picture 3) : remove the seal at the bottom of the pipe, and remove the pipe from the
top of the lid. Clean it under running water. Take care that the duct is properly cleaned. Dry thoroughly the seal
and the pipe before putting the valve back in its original position.
• To clean the pressure limit valve (picture 4): remove the valve weight gently from the top of the lid and rinse it
under running water, paying special attention to the inside. Dry it off thoroughly. Take care also that the duct
of the valve on the lid is properly cleaned before putting the valve weight back in its original position.
• To clean the strainer of the valve (picture 5) (under the lid) : pull the strainer slightly to unclip it. Then clean
it under running water. Dry it off thoroughly. Then put it back in its original positon (you should hear a "click"
sound and the valve strainer must be close up against the inside of the lid).
• Ensure that the safety valve (picture 6) is working properly, by pushing it slighly with the finger, checking that
there is no dirt or remaining food. But never attempt to unscrew it.
• Clean the removable cooking bowl and the accessories. Only the accessories are dishwasher safe. Do not use a
scourer to clean the bowl as this can damage the non stick coating on the bowl.
• Remove the condensation collector and clean it thoroughly under running water. Put it back in its original
position.
EN
29