Rice - all-clad NC00134439 Guide D'utilisation

• If the temperature needs to be modified, press the
buttons. This will not affect the time setting.
• Once the settings are selected, press the
And the display shows
• You can place the ingredients in the cooking bowl. It will then switch automatically to the cooking phase, the
time will be counting down.
• You can change the time or temperature settings during cooking: press the
value by pressing the
• Once the new settings are selected, press the
• At the end of the count down the appliance will beep 3 times to announce the end of cooking.
NOTE : The button is not active for this function.
The KEEP WARM is not active for this function.
• Open the lid of the appliance.
• Measure out the rice and rinse it thoroughly under running water in a strainer for a long time (except for risotto
rice which should not be rinsed). Then place the rice in the bowl with the corresponding quantity of water.
• Make sure the rice is well distributed around the whole surface of the bowl in order to allow even cooking.
• Add salt to your personal taste if required.
• Water may be substituted for stock. If using stock, there is the risks of slightly browned rice on the bottom.
• Close the lid.
• Press any button to activate the unit. The display will blink.
button: the appliance will beep to indicate the start of preheating.
.
buttons.
button to continue cooking.

RICE

button and adjust the value by pressing the
or button and adjust the time
EN
25