General Description. Technical Characteristics - gala gar Gala Cut 700 Manuel Technique D'instructions

1. GENERAL DESCRIPTION. TECHNICAL CHARACTERISTICS.

Electric plasma cutting equipment blown with compressed air. Manual and automated cutting of all types of
electricity conductor materials: Steel, stainless steel, aluminium, brass, etc. High Portability Inverter System
TECHNICAL CHARACTERISTICS
Supply voltage (U1–3Ph 50/60 Hz)
Maximum primary intensity - I1max
Primary effective intensity I1eff
Maximum absorbed/effective power (P1max/P1eff)
Maximum steel cutting thickness (separation)
Cutting current regulation margin I2
Maximum cutting intensity
Built-in torch
Recommended compressor
Semi-automatic filter and discharging system
Reignition work mode (Grating cutting)
Gouging process
Protection against overheating/ pressure drop
Degree of IP mechanical protection
Dimensions (W x L x H)
Weight (Without transport trolley)
According to standards EN60974-1, EN60974-7 and EN60974-10
Technical characteristics of cutting torch (Standard EN 60974-7)
USE ONLY THE RECOMMENDED SPARE PARTS AND ACCESSORIES
Maximum cutting thicknesses according to the material
Top quality
Maximum
Maximum trimming
Technical characteristics of PLAMA CUT equipments
Technical characteristics
Current range
Duty cycle
Gas
Pressure
Minimum air flow
Ignition mode
NEVER USE THESE PLASMA CUTTING MACHINES TO DEFROST TUBES.
GALA GAR has a complete range of cutting accessories where you can find those most
suited to your needs.
GALA CUT 700
GALA CUT 700
Stainless
Steel
steel
20 mm 15 mm
25 mm 18 mm
30 mm 20 mm
P-106
Ref.: 1609740
20-100A
100A - 60%
Air
4.6 – 5.0 bar
200 l/min.
Without HF (Ptorch ®)
Aluminium
17 mm
20 mm
25 mm
GALA CUT 700
Ref. 46300000
400-440V  10%
16/15 A
12/11 A
11/8.3 KVA
25 mm / 30 mm
20  70 A
70 A / 60%
55 A /100%
P-80
4 CV – 480 l/min
YES
YES
YES
YES
IP21S
520x380X340 mm
25 kg
14