gala gar Gala Cut 700 Manuel Technique D'instructions page 21

4.2 RECOMMENDATIONS FOR REDUCING ELECTROMAGNETIC COMPATIBILITY (CEM) PROBLEMS.
The user is responsible for the installation and use of the cutting material according to the instructions in this
manual and the following recommendations.
Before installing the cutting material, the presence of the following in the surrounding area must be kept in mind:
• Wiring for power, control, signalling, and telephones.
• Radio and television receivers and transmitters.
• Computers and other control equipment.
• Critical security equipment.
• People with pacemakers or hearing aids.
• Measurement and calibration equipment.
In order to reduce EMC problems, keep in mind the time of day when cutting or other activities will be carried out.
Move possible interference victims away from the cutting station.
The device, following the EMC classification of equipment according to CISPR 11, meets group 1 class A.
ALWAYS CONNECT THE MACHINE TO POWER GRID USING AN EFFICIENT GND.
IF PROTECTIVE DEVICES OR SUPPLEMENTARY ELECTRICAL SYSTEM FILTERS ARE NEEDED, CONSULT OUR
PERFORM THE MAINTENANCE OPERATIONS DESCRIBED IN THIS MANUAL.
USE THE SHORTEST CONDUCTOR CABLES POSSIBLE AND KEEP THEM PLACED NEXT TO EACH OTHER NEAR THE
IF THE PIECE TO BE CUT IS GROUNDED, KEEP IN MIND OPERATOR SAFETY AND NATIONAL REGULATIONS.
GALA CUT 700
CONSUMABLES REPLACEMENT
TECHNICAL SERVICE.
FLOOR.
21