gala gar Gala Cut 700 Manuel Technique D'instructions page 17

3. 2 OPERATIONS SEQUENCE FOR STARTING UP THE EQUIPMENT.
10. Select and place the type of accessories according to the work to be carried out (See section 3.1.3).
11. Connect the plug to the power grid.
12. Connect the ground clamp to the piece to be cut.
13. Connect the air supply and regulate the pressure (5.5-6 bar in vacuum).
14. Carry out the ignition process by means of the general ON / OFF switch (item 8)
15. Determine Work Mode by item 3 selector.

Position 1: General cutting mode on flat, grids and contact cutting (Mod. A) and B).)

Position 2: Gouging
16. Connect the equipment and adjust the desired working current using the potentiometer "1".
17. You can now start the cutting operation.
3.3 WORKING MODES. SELECTION AND INSTALLATION OF ACCESSORIES.
You can consider 3 work modes that will require a specific spare parts KIT. The electrode (Item 3)
A - GENERAL CUTTING MODE ON
FLAT AND CUTTING OF GRIDS
GALA CUT 700
Item Reference
3 GG1652556B5
SPARE PARTS KIT FOR TORCH P-106
B - CONTACT CUTTING MODE
Description
Electrode PT-106
C- GOUGING CUTTING MODE
17