Control Access - Napoleon HDX35NT Instructions D'installation Et D'opération

10.2 CONTROL ACCESS

Once the appliance has been framed and fi nished, control access can only be achieved by removing the
access panel from the inside right side of the fi rebox. The following sub sections take you through the steps
of accessing the control as if the appliance is installed.
*Prior to removing the control panel follow the "DOOR REMOVAL" process and then follow the media
removal instructions located under the "MAINTENANCE" section.
NOTE: IT WILL BE NECESSARY TO REPLACE THE GASKET (W290-0238) FOR THE ACCESS PLATE
IF THE UNIT HAS BEEN PREVIOUSLY OPERATED BEFORE REMOVING THE PLATE (W290-0238).
A. Remove the media from the appliance, follow removal instructions under the " MEDIA REMOVAL"
section.
B. Remove the right side brick / porcelain panel, follow removal instructions under the " BRICK /
PORCELAIN PANEL REMOVAL" section.
C. To remove the glass media trays to remove the glass burner, follow removal instructions under the
"MEDIA TRAY" section (glass burner only).
D. Remove the grate before removing the brick / porcelain panels, follow removal instructions under the
"GRATE REMOVAL" section (log burner only).
E. To access the controls remove the 8 screws securing the access plate from inside the fi rebox.
F. Care should be taken to ensure avoiding damage to the gasket.
G. Reverse this process to install the control access. Ensure the access plate is well sealed to the
appliance.
49
RIGHT
SIDE
PRE INSTALLATION
ACCESS
W415-1434 / 06.09.15
EN