F.F. Group GCS 441 PRO Notice Originale page 25

GCS 441 PRO | GCS 450 D PRO
File
diameter
Type
of
chain
21BPX 3/16"
IMPORTANT
Be sure to round off the front edge to reduce the
chance of kickback or tie-strap breakage.
Make sure every cutter has the same length and edge
angles as illustrated.
GUIDE BAR
Reverse the bar occasionally to prevent partial
f
wear.
The bar rail should always be a square. Check for
f
wear of the bar rail. Apply a ruler to the bar and
the outside of a cutter. If a gap is observed be-
tween them, the rail is normal. Otherwise, the
bar rail is worn. Such a bar needs to be corrected
or replaced.
(1) Ruler (2) Gap (3) No gap (4) Chain tilts
f
Top plate angle Down angle
Vise rotate angle Vise angle
30°
Depth gauge
Head angle (55°)
Side angle
10° 85°
STORAGE
1. Empty the fuel tank and run the engine out of fuel.
2. Empty the oil tank.
3. Clean the entire unit.
4. Store the unit in a dry place out of the reach
of children.
ENVIRONMENTAL PROTECTION
Recycle raw materials instead of disposing as waste.
Machine, accessories and packaging should be sorted
for environment - friendly recycling. The plastic com-
ponents are labeled for categorized recycling.
WARRANTY
This product is warranted in accordance with the legal/
country specific regulations, effective from the date
of purchase by the first user. Damage attributable to
normal wear and tear, overload or improper handling
will be excluded from the warranty. In case of a claim,
please send the machine, completely assembled, to
your dealer or the official service center. The warranty
period applied for these specific models of chainsaws,
are three (3) years for non-professional use and one
(1) year for professional use.
English |
Depth gauge
standard
0.025°
File
www.ffgroup-tools.com
25