Publicité
Les langues disponibles
Les langues disponibles
MOUNTING (CONT.)
Drill two 7/16" (12mm) diameter
holes with center lines exactly
3-11/16" (93.66mm) apart (Figure 7)
in the support chosen for the
winch. Attach the winch to the sup-
port with two (2) 3/8-16 Hex Head
Bolts. Be sure the hardware is
assembled as shown. Tighten the
hardware to 35 lb. ft. torque.
Flat Washer
Lock Washer
Nut
Figure 7
ELECTRICAL INSTALLATION
This winch operates on standard
automotive 12-volt Direct Current.
to 110 Volt house current. Motor
damage or fatal shock may occur.
tain gasses which are flammable and
explosive. Wear eye protection dur-
ing installation and remove all metal
jewelry. Do not lean over the bat-
tery while making connections.
The red wire from the switch is
connected to the circuit protector
terminal using the hardware pro-
vided. The other end of the circuit
protector is connected to the bat-
tery positive terminal. The black
wire from the switch is connected
6
Bolt
Flat Washer
Support
Do not
connect winch
Be Prepared
Automobile
batteries con-
to the battery negative terminal
(Figure 8). Be sure connections are
clean and tight. Do not connect the
switch or wiring to any other power
source in the vehicle.
Circuit
Chassis
Protector
Ground
Black
Figure 8
Starting at the winch, feed the
wires into the engine compartment.
If possible, use the routing and sup-
port for the existing wiring.
If it is necessary to drill holes, to
feed the wires, be sure the wires
are protected from damage by
using a grommet (Figure 9). Use
cable ties to secure wires along the
route.
Figure 9
When you make the ground con-
nection, be sure to scrape off any
dirt from the bolt that would pre-
vent a good connection.
Note: If the winch is mounted at
the rear of the vehicle, a special
wiring kit (P/N 1520) is available
from Superwinch.
When extending the lead wires for
rear vehicle mount, always use 8
gauge wire or heavier to extend the
existing wires to the battery.
Red
Grommet
Tie Strap
Publicité
