Horizon Global PRO Serie Manuel D'instructions page 71

TOYOTA TUNDRA 2000 to 2006 (STANDARD CAB LONG BOX ONLY)
Read pages 2-3 of these instructions before starting installation. Failure to do so could result in significant vehicle damage!
NOTE: For Toyota Tundra application, part #58197 spacer kit is required. Stack (1) 3/16" and (1) 5/16" thick
slotted spacer to avoid crushing of truck bed.
Front
of
Vehicle
NOTE:
Must install center bolt in
one of the center holes in
each rail.
Check to make sure center
bolt does not interfere with
bed sill.
King Pin Centered approx. 1-1/4"
forward of Axle Center
Front
Side Bracket
of
Vehicle
Long bracket
1/4 1.5-3
*
1/4 2
Check for obstructions before drilling. Failure to do so could result in damaged fuel or brake lines, structural members, etc.
Horizon Global America Inc. does its best to communicate tow vehicle manufacturer changes; however, it is ultimately the
©
2006,2007,2008,2009,2010,2011,2012,2013, 2014, 2017 Horizon Global America Inc .
CAUTION!
CAUTION!
responsibility of the installer to prevent damage due to installation.
SHEET 16 0F 19
Made in China
Rear Edge of
32-1/2" Long Box (Only)
Measure from Rear Edge of truck
bed to rear edge of base rail.
Axle Center
Drivers side shown
1/4 2
*
1/4 2
30035IN 1/31/2017
Truck Bed
Short bracket
* Optional weld
pattern
Rev. U