Horizon Global PRO Serie Manuel D'instructions page 66

DODGE (RAM) '02-08' 1500 / '03-12' 2500 WITHOUT OVERLOAD BRACKETS
('03-12' 2500 WITH OVERLOAD AND 3500 REQUIRED BRACKET KIT 58186,
Read pages 2-3 of these instructions before starting installation. Failure to do so could result in significant vehicle damage!
IMPORTANT NOTES FOR THIS INSTALLATION:
1. Tube spacer and 4 1/2" carriage bolt used to attach through rearward Bed Sill (Row 3).
2. **Rib neck bolts will need to be pulled through access holes in frame with supplied pull wire (see below).
3. Do not drill through both
walls of frame. Drill only
through wall of frame to
which bracket is mounted.
4. It is very important that
brackets in Row 2 are against
rear side of Bed Sill as shown.
Due to dimensional instability in
Bed Sill placement with the
Dodge truck, interference could
result when drilling in Row 3.
Observe caution note below and
double check all areas prior to
drilling.
5. To avoid drilling inside of
frame, (Passenger Side
Row 3) Optional Custom
Bracket (58023) can be
purchased from your
dealer if needed. The use
of this bracket allows for
drilling outside the frame
and avoids exhaust
hanger.
6. *Due to tubular frames
having thinner walls than
previous C channel
frames, extra caution
needs to be used when
mounting with the optional
welding.
Side Bracket
Front
of
Bed Sill
Vehicle
Long bracket
1/4 1.5-3
*
1/4 2
Check for obstructions before drilling. Failure to do so could result in damaged fuel or brake lines, structural members, etc.
Horizon Global America Inc. does its best to communicate tow vehicle manufacturer changes; however, it is ultimately the
©
2006,2007,2008,2009,2010,2011,2012,2013, 2014, 2017 Horizon Global America Inc .
Front
of
Vehicle
King Pin Centered
over Axle Center
Short bracket (passenger
side), inside frame.
responsibility of the installer to prevent damage due to installation.
SHEET 11 0F 19
Made in China
CAUTION!
Drill through
Bed Sill with
17/32" drill.
Open up hole
through truck
bed only with
1" dia. drill.
Drop tube
spacer through
hole in truck
bed to avoid
crushing Bed
Sill when
torquing 4-1/2"
carriage bolt.
Use provided tube spacer and 4-1/2"
carriage bolt to attach through Bed
Sill
Drivers side of 1500 Ram Long box Shown
Short bracket (driver's side) outside frame
1/4
1/4
**Rearward access hole (in bottom of frame)
CAUTION!
30035IN
See page 18
NOTE:
Must install center bolt in
one of the center holes in
each rail.
Check to make sure center
bolt does not interfere with
bed sill.
Rear Edge of
Truck Bed
28-5/16" Long Box
26-5/16" Short Box
Measure from Rear
Edge of truck bed to
rear edge of base rail.
2
*
*
Optional weld
2
pattern
1/31/2017
)
Rev. U