Horizon Global PRO Serie Manuel D'instructions page 37

INSTALLATION
1. These instructions should be used to mount the slider. Care and attention to detail will ensure a quick, safe and
quality installation. Check parts against figure 1 to become familiar with kit.
2. Before installing the slider, leaf spring must be
greased as shown using white lithium grease or
equivalent (see figure 7). For best results, use
aerosol white lithium grease with a spray nozzle
extension. Make sure entire underside of spring is
coated! Repeat this application monthly during use.
3. Before setting the slider into the bed of the
pickup, attach handle shaft to handle elbow (see
figure 1 on first page). Insert handle assembly
through left hand slide assembly (driver's side of
towing vehicle) and then through the right hand side
slide assembly (see figure 8).
If 5 TH wheel PRO-SLIDE is being used with the
PRO-SERIES 16k head assembly insert handle
through right hand slide assembly (passenger side of
towing vehicle) and then through left hand side of
slide assembly.
4. Set the slider into base rails and pin in
position with the slider in the middle of the
tubes (see figure 9).
slider Upright
Slide Tube
figure 9
30092IN– 9/22/17 PCN8340
See figure 10 for
installed clip locations.
©2011, 2015 HORIZON GLOBAL AMERICAS INC
Aerosol white lithium
grease spray with nozzle
extension
figure 7
figure 8
Leaf spring
Reference label
facing driver side.
WARNING:
Pull pin spring clips must
be on the outside of base rail
as shown. Spring clips
installed on the inside of
base rail will not allow slider
to slide far enough to lock.
Sliders that are not properly
locked can suddenly move
and cause serious injury or
death.
Printed in Mexico
4